Joes Guide To Abide By If Searching For Cable Lighting Kits
Landscape lighting is one method which you can instantly add curb charm to your home. Whether or not you’re planning on illuminating a walkway–or your goal is to actually show off your well-tended flower garden, landscape lighting can be precisely what you’re searching for. With nowadays’s simple-to-install landscape lighting kits offered at nearly all hardware stores–the task could not be easier. Here is how to put in landscape lighting.
The 1st thing to putting in your landscape lighting is to work out how you are going to run the lights. How much area are you wanting to cover? Is your project answering safety concerns or is it stricly for visual charm? The number of lights you are planning to use plus how long of a run it will need are two criteria you’ll have to understand before you are able to get the materials.
The basic rule of landscape lighting is: If you have a hundred-foot run and the overall lights you are going to use are drawing less than or up to one hundred fifty watts, then you’ll need 16 gauge UF cable. If you’ve got a 150-foot run and the lights you’re going to use are drawing less than or up to two hundred watts, then you will wish to have fourteen gauge UF cable. If you have a two hundred-foot run and the final lights you are going to use are drawing not more than or up to 250 watts, then you’ll wish to have twelve gauge UF cable. Learn more about cable lighting kits here.
Find the closest outside receptacle to where you’re putting in your landscape lights. If the receptacle is simply not already a GFCI receptacle, then you will have to replace it with one every one of your landscape lights where you want them to stand. Attach the bottom spikes to the underside of the lights plus drive them into the ground. Be sure [that the] wire leads remain above the surface of the ground. With all of your landscaping lights in position, using the hand shovel to dig a trench the length of the run, approximately six inches deep. Lay the UF cable within the trench (be certain to leave enough behind to reach the place where you are putting in the transformer) and clip each light fixture’s wire ends up in the UF cable. At the awfully last light in the chain, employ [electrical] tape to cover up the end of the UF cable very tightly. Then, bury the cable with the dirt you removed to create the trench.
On the bottom or on the backside of the transformer, you’ll see two screw terminals. Split the UF cable into 2 separate wires (about three-in. lengths). Use the wire strippers to strip away approximately 3/4 inches of insulation from every wire. Use the screwdriver to secure 1 wire to every terminal. Hang the transformer under an overhang if you are able to, near the receptacle you’re going to use for power. Open up the transformer’s cover and set the clock to the present time. Then use the colored tabs to indicate when the lights will turn on and off. Now the only thing you have got to carry out is plug the transformer in plus wait till the time you have got the transformer set to turn on your lights. Or if you can’t wait [to see] your handiwork in action, simply hit the “manual test” button if your transformer has 1!
Mail this post
Tags: cable lighting, cable lighting kit, cable lighting kits